TSB : Power Rack & Pinion: Installation

Details

To install, reverse removal procedure. Install NEW "O" rings on hoses (if equipped). Coat "O" rings with ATF before installation. Ensure proper sized "O" ring is installed. Align reference mark on lower joint and pinion shaft. Tighten nuts and bolts to specification. See TORQUE SPECIFICATIONS (STEERING GEAR) table under TORQUE SPECIFICATIONS. Fill and bleed system. See HYDRAULIC SYSTEM BLEEDING under LUBRICATION. Check front wheel alignment if tie rods were removed or steering gear was overhauled. See NISSAN - SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.