TSB : Removal & Installation (Bronco II & Ranger)

Details

Disconnect battery ground cable. On vehicles equipped with 2.9L engines, remove vacuum reservoir and solenoid box cover in front of blower motor. For vehicles equipped with 2.3L EFI engine, remove air cleaner in front of blower motor. On all models, disconnect wire harness connector from blower motor by pushing down on connector tabs and pulling connector off motor. Disconnect blower motor cooling tube at blower motor. Remove 3 screws attaching blower motor and wheel to heater blower assembly. Holding cooling tube aside, pull blower motor and wheel from heater blower assembly and remove from vehicle. Remove blower wheel hub clamp from motor shaft. Pull blower wheel from motor shaft. To install, reverse removal procedure.