TSB : Pressure Sensitive Type (All Full Width, 40-40, 60-40, and 50-50 Seats)

Details

Where present, remove seat cushion side panel and control switch. Remove seat adjuster-to-floor pan attaching bolts (driver's side only on Cadillac 60-40 seat) and tilt seat rearward (passenger seat only on 40-40, 60-40, and 50-50 seats). On all split seats, remove outboard adjuster from seat frame. On bench seats, remove adjuster adjacent to affected sensor. Detach trim cover from side of seat cushion sufficiently to gain access to sensor. Disconnect sensor wire at connector under seat. Carefully break cement bond securing sensor to foam pad; then pull sensor wire up through hole in foam pad and remove sensor. To install sensor, reverse removal procedure. Prior to installing a new sensor, remove adhesive protective paper from bottom surface of sensor. NOTE: If repositioning used sensor, apply a small amount of trim cement to cushion and bottom or sensor. Then apply a strip of waterproof body tape over sensor to secure during trim reinstallation. Do not apply tape too tightly over switch.